Evido EAD-B1000 Manual do Utilizador descarregar pdf (Página 12)

July 24, 2008 6 Digital Broadcaster User Manual v. 3.4 rev. 3421

6. The Digital Broadcaster resets with the new IP address information. After a few

seconds the server reboots. When the reboot finishes the continuity clip begins to

play.

Using a cross-over cable to change the server IP address:

To use a cross-over cable to set the IP address for the Digital Broadcaster you will connect a

computer, such as a laptop or PC, to the default network.

Note: If you used WriteIP.exe to set the server IP address, skip this section

and go to Using Webmin to Configure Server Settings on page 9.

Connect the supplied cross-over cable between a computer such as a laptop and the primary

Ethernet port on the Digital Broadcaster. The primary port is on the left. On models with

more than one Ethernet port, it might be labeled “LAN 1” or “eth0”.

If using a cross-over cable and a PC with Windows XP:

1. From the Start menu, choose Settings . . Network Connections.

2. Double-click on the Local Area Connection icon to open the Local Area

Connection Status window. Click the Properties button to open the Local Area

Connection Properties window.

3. Select Internet Protocol (TCP/IP) and click the Properties button to open the

Internet Protocol (TCP/IP) Properties window.

Use the left

Ethernet port.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Sem comentários

Evido EAD-B1000 Manual do Utilizador Página 12