Evido EAD-D2000 Manual descarregar pdf (Página 14)

To configure the setting values of the product, click Setup on the main page. A Viewer is not

allowed to enter the Setup page. Log in to the webpage with the Operator or Administrator

account to change the setting.

When you configure the device, make sure to consider the DSP usage. Too high of DSP load

could affect the performance of the encoder or frame drop. For the best performance, avoid

to consume too high DSP resources for both of 1st stream and 2nd stream.

Note

Refer to below for the approximate DSP usage. The figures are estimated

under the condition of D1 resolution, 1.5 Mbps bitrate, and only 1 channel

occupied.

MJPEG 20~25%

MPEG4 around 60~65%

H.264 around 75% ~ 80%

MD 3%

VCA 20% ~ 25%

To access the Setup page do the following:

1. Enter “root” and “pass” (case sensitive) in the User ID and Password. (The root is the

default setting for these fields.)

2. Click the OK button to access to the Setup page.

At the bottom of the every page of Setup, you can see two buttons as listed below:

Apply – Sends a request to the product server and get the expected result

Reset – Removes the typed values or settings of current page and returns to the original

setting

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 95 96

Sem comentários

Evido EAD-D2000 Manual Página 14