Evido EAD-D2000 Manual descarregar pdf (Página 43)

To change the NAT setting, go to Setup > System Options > NAT.

If you select to enable RTSP connection via public IP address, the IP address or domain name

will be automatically retrieved from the URL tab of the device web page. In order to see the

device’s webpage and streaming on the web page, both HTTP port and RTSP port should be

forwarded.

Suppose you set the IP address of the router to 112. 216.89.172 and forward the HTTP port to

8080 and RTSP port to 22230. Then, for the port forward setting:

1. Check the box of ‘Check this box to enable RTSP connections on a different port when the

unit is accessed via its public (NAT) IP address.’

2. Type the RTSP port number that your router knows. Check the RTSP port number stated in

System Options > RTSP/RTP.

3. Click the Apply button.

4. If you want to go back to the previous setting, click the Reset button.

When you use domain name, you should check out if the DNS or DDNS is enabled.

Go to System Option > TCP/IP for DNS setting.

Go to System Option > DDNS for DDNS setting.

If you want to access the webpage you should use the IP address of the router plus the port

number. (http://112.216.89.172:8080) If you do not configure the RTSP port forwarding

properly you will see the error message.

Note

Prior to the NAT setting, the port forwarding of router should be done manually. It

does not provide any automatic NAT traversal service.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 95 96

Sem comentários

Evido EAD-D2000 Manual Página 43