Evido EAD-D2000 Manual descarregar pdf (Página 44)

To change the NTP service setting, go to Setup > System Options > NTP.

NTP Server Lists

You can set up to 4 NTP servers as you can see at the example of above. To enable the NTP

servers, DNS server setting should be done in advance in the menu of TCP/IP page and please

check out if the DNS configuration is accurate.

I am SNTP Server

It is also called ‘Squid server.’ When you have multiple servers for the device, it helps to reduce

the network load because only the one with ‘I am SNTP Server’ checked will get the time

information from the NTP servers and other servers for the device are synchronized with this

Squid server.

How to use:

1. Enable ‘I am SNTP server’ of squid server and click Apply.

2. Access the webpage of the device which is supposed to be the client device of the

squid server. Go to System Options > NTP and type the IP address of squid server on

the ‘NTP Server 1s’t. (Format example : 192.168.11.4)

3. Click ‘Test’ button to find out if it works fine.

Note

It will take about 3~4 minutes until the squid server response.

4. Go to Setup > Basic Configuration > Date & Time and choose the ‘Synchronize with

NTP server’ for the method of New Server Time menu. Make sure if the ‘NTP Server’

displays the designated squid server’s IP correctly with red characters.

5. Click ‘Apply’ button and it will be restarted.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 95 96

Sem comentários

Evido EAD-D2000 Manual Página 44